Limited Lifetime Warranty
Locations
Register
Trimming drawer organizer parts is relatively quick and easy. Using a general purpose carbide tipped blade and masking tape to avoid chipping, simply mark the area that requires cutting and make your cuts.
Trimming Zones
Trim zones are the recommended areas to cut in order to tailor drawer kit components to your client's drawer box.
Autograph
Most trim zones for Autograph components are located at the rear and side of the individual part.
*Click the image to view larger
Exceptions
Imprint
Most trim zones for Imprint components are located at the rear and side of each piece.
Exceptions
Trimming Pegboards for Deep Drawers
For depth trimming, cut the rear portion of the pegboard in order to keep the front edge with the finger hole (to remove the board from the drawer) intact.
For width trimming, cut the pegboards evenly on both sides, allowing the finger hole to remain in the centre.
E.g. If the pegboard requires a trimming 3 inches off the width, trim 1-½ inches from either side of the board.
Anti-Slip Mats
Mats are easily trimmed with a utility knife to any desired size.
Area
Trimming Area trays is as simple as acquiring the exact measurements of the interior of the drawer box, marking the where you want to trim on the lip of the tray and making your necessary cuts on a table saw.
Login